All Wheel Drive (AWD): Pump: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- The hydraulic pump -A- is installed inside the hydraulic control unit in its Installed position; assembling the hydraulic pump. Refer to Figure.
- The adapter -B- is installed into the recesses in the hydraulic pump.
- The new O-ring -D- is installed on the AWD pump.
-- Install the AWD pump and the shaft -C- into the adapter -B-.
-- Tighten the four bolts on the AWD pump -2- diagonally HYDRAULIC CONTROL UNIT => List Item:Bolt.
-- Connect the connector -1- to the AWD pump.
-- Fill the ATF in the rear final drive. Refer to ATF IN REAR FINAL DRIVE 0BF AND 0BE, FILLING .