AWD Control Module

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All Wheel Drive (AWD) control module -J492- locations -item 1- ELECTRICAL AND ELECTRONIC COMPONENTS AND COMPONENT LOCATIONS => List Item:All Wheel Drive (AWD) Control Module -J492-.

The description for removing and installing is based on the Audi A4 Sedan.

Turn off the ignition.

-- Remove the luggage compartment floor covering.

-- Remove the cover and vehicle tools bracket.

-- Unclip the AWD control module -A- from its mount -C-.

Fig 1: All Wheel Drive (AWD) Control Module -J492- In Audi A4 Sedan, Audi A5 Coupe And Audi A5 Cabriolet

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -B- from the AWD control module.

-- Install the AWD control module in reverse order of removal.

Additional work will be necessary if the AWD control module was replaced. Refer to AWD CONTROL MODULE, ADDITIONAL WORK AFTER REPLACING .