LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Final Drive & Differential - Automatic Transmission) >> 39 Final Drive, Differential >> Gear Oil >> Gear Oil, Draining And Filling >> Gear Oil, Draining And Filling, Transmission With Combined Oil System >> Filling and Adjusting

Filling and Adjusting

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the Used Oil Collection and Extraction Unit SMN 372500 under the transmission.

Fig 1: Identifying Drain Plug From Front Final Drive
GWWA39-10415Courtesy of AUDI OF AMERICA, LLC
WARNING:

Danger of eye injury.

  • Wear protective eyewear.

-- Remove the plug -arrow A- from the front final drive.

-- Install the Adapter VAS 6617/6 with the Adapter VAS 6617/2 in the inspection and fill hole in the front final drive.

Fig 2: Installing Adapter VAS 6617/6 & Adapter VAS 6617/2 Into Transmission Hand-Tight
GWWA39-10510Courtesy of AUDI OF AMERICA, LLC

-- Connect the Pressurized Gearbox Oil Filler Kit VAS 6617 and fill the front final drive with approximately 1 liter of gear oil.

-- Wait five minutes.

NOTE: A waiting time of at least 5 minutes is required so that the internal oil level between the differential and oil fill space can equalize.

-- Remove the Adapter VAS 6617/6 from the transmission and let any extra oil drain out.

-- Install the old plug.

-- Remove the drain plug -arrow A- from the center differential housing.

Fig 3: Drain Gear Oil From Transfer Case
GWWA39-10188Courtesy of AUDI OF AMERICA, LLC

-- Install the Adapter VAS 6617/6 with the Adapter VAS 6617/2 in the inspection and fill hole in the transfer case hand-tight.

Fig 4: Installing Adapter VAS 6617/6 & Adapter VAS 6617/2 In Inspection & Fill Hole In Transfer Case
GWWA39-10509Courtesy of AUDI OF AMERICA, LLC

-- Connect the Pressurized Gearbox Oil Filler Kit VAS 6617 and fill the transfer case with approximately 1 liter of gear oil.

-- Wait five minutes.

NOTE:

The inside of the transfer case is divided into several oil chambers. The chambers must be filled equally.

A waiting time of at least 5 minutes is required so that the internal oil level between the center differential and oil fill space can equalize.

-- Remove the VAS 6617/6 from the transmission and let any extra oil drain out.

-- Install the old plug.

-- Perform a road test for 10 to 15 minutes.

NOTE: The fluid distributes evenly during the road test.

-- Check the gear oil level and fill. Refer to GEAR OIL, CHECKING LEVEL .