Flywheel, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Carefully Set Down Electro-Drive Drive Motor

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Always clean the transmission housing in the area where the differential is accessed -arrow A- and the shaft seal -arrow B-.

NOTE:

Replace the shaft seal between the differential and transmission housing -arrow B- if it is damaged, refer to LEFT SEAL, REPLACING .

-- Fill the space between the sealing- and dust lip half way with sealing grease .

-- Clean the input shaft -arrow-.

Fig 2: Identifying Input Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Lubricate the input shaft splines using Grease for Clutch Disc Shaft Splines G 000 100.

-- Slide the clutch module onto the input shaft -arrow- carefully without tilting it.

Fig 3: Identifying Flywheel Components, Remove/Install

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Puller - Clutch Module T40176 from the flywheel -A-.

Fig 4: Identifying Nut

Courtesy of AUDI OF AMERICA, LLC

-- Install the left flange shaft, refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .