Transmission, Removing, Vehicles With 4.0L TFSI Engine: Notes
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Pry lever 80 - 200
- Engine and Gearbox Jack VAS 6931
- Hose Clip Pliers VAS 6362
- Tensioning Strap T10038
- Gearbox Support T40173
- Crankshaft Turning Tool T40272
Preparing the Gearbox Support T40173:
-- The bracket attached to -item 1- must be removed.
-- The bracket -item 2- must be turned so that the longer side faces up as illustrated.
WARNING:
Before using the Gearbox Support T40173 always check if it meets the requirements.
The older version mounts, should not be used and should be replaced.
Characteristics (Newer Version)
On the newer version the components illustrated -red- are -yellow - chrome plated. See Figure.
If the mount does not comply with corresponding specifications, proceed as follows:
- German market: Contact the company Matra for an exchange.
- Other markets (worldwide outside of Germany): Contact your supplier for an exchange.