Transmission, Removing, Vehicles With 3.0L TFSI Engine: Notes

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Pry lever 80 - 200
Engine and Gearbox Jack VAS 6931
Tensioning Strap T10038
Motor Transport Loop T40016
Crankshaft Socket T40058
Gearbox Support T40173

Preparing the Gearbox Support T40173:

Fig 1: Brackets Attached To -1- And -2-

Courtesy of AUDI OF AMERICA, LLC

-- The bracket attached to -item 1- must be removed.

-- The bracket -item 2- must be turned so that the longer side faces up as illustrated.

Fig 2: Chrome Plated Components

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Before using the Gearbox Support T40173 always check if it meets the requirements.

The older version mounts, should not be used and should be replaced.

Characteristics (Newer Version)

On the newer version the components illustrated -red- are -yellow - chrome plated. SeeFigure.

If the mount does not comply with corresponding specifications, proceed as follows:

German market: Contact the company Matra for an exchange.
Other markets (worldwide outside of Germany): Contact your supplier for an exchange.