Selector Mechanism, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Install the selector mechanism function unit and tighten it from the top.
-- Install selector lever cable. Refer to Installing .
-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
-- Check the selector mechanism. Refer to GEARSHIFT MECHANISM, CHECKING .
-- Install the driveshaft intermediate bearing. Refer to REMOVAL AND INSTALLATION or REMOVAL AND INSTALLATION .
-- Install the front ashtray or storage compartment. Refer to FRONT ASHTRAY, REMOVING AND INSTALLINGCenter Console .
-- Install the selector lever handle. Refer to Installing .