Overview - Selector Lever Cable

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Selector Lever Cable Assembly

Courtesy of AUDI OF AMERICA, LLC

Clip
- For selector lever cable
- Replacing
Bolt
- 8 Nm
- Quantity: 2
Selector Lever Cable
- Do not bend
- Removing and installing. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING .
- The selector lever cable must be replaced if the rubber grommet is damaged.
- Lubricate the ball socket lightly with Polycarbamide Grease G 052 142 A2 before installing.
- Make sure the rubber grommet on the transmission side is not twisted when installing.
- Adjusting. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
- Bring into Installed Position. Refer to SELECTOR LEVER CABLE, BRINGING INTO BASIC SETTING .
Cable Mounting Bracket
Bolt
- For selector lever cable adjustment
- Attached to the selector mechanism function unit
- 13 Nm
O-Ring
- Replacing
Gearshift Lever

Fig 2: Heat Shield And Bolts

Courtesy of AUDI OF AMERICA, LLC

Bolts - top arrows- : 9 Nm.
Bolt - bottom arrow- : 20 Nm.