Button In Handle, Moving Into Installation Position

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Locking Button Removal Tool T40203

PROCEDURE

Fig 1: Turning Locking Ring

Courtesy of AUDI OF AMERICA, LLC

The locking button -2- projects out in its installation position in the handle.

If the locking button was pressed in, then it must be brought back to it installation position so that the handle -3- can be installed.

NOTE:

To improve the illustration, the handle is shown without the selector lever boot for the following steps.

Fig 2: Resetting Lock Button With Tool T40203

Courtesy of AUDI OF AMERICA, LLC

-- Carefully install the Locking Button Removal Tool T40203 all the way into the handle -1-.

The cut-out on the Locking Button Removal Tool T40203 faces the locking button and the hook toward the left.

-- Hold the handle -A- tighten and turn the Locking Button Removal Tool T40203 180° in direction of arrow -1-.

Fig 3: Resetting Lock Button With Tool T40203

Courtesy of AUDI OF AMERICA, LLC

-- Hold the handle tight and carefully remove the Locking Button Removal Tool T40203 -arrow 2-.

While the Locking Button Removal Tool T40203 is being removed, the locking button -A- on the handle will be pushed out and will lock.

Fig 4: Resetting Lock Button With Tool T40203
Courtesy of AUDI OF AMERICA, LLC
Do not touch the locking button anymore before installing the handle so that the button does not fall back in.