Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING: Notes
WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Caution:
Do not use the Hook And Support Tool T40197 for the following described work procedures - There is a risk of injury.
Only use the Hook and Support Tool T40294 for this operation.
Special tools and workshop equipment required
- Hook and Support Tool T40294
- Counterhold - Side Shaft T40217
- Sensor Module Tool T40228
- Sealant
NOTE:
The Transmission Input Speed Sensor 2 -G612-, Transmission Input Speed Sensor 1 -G632-, Drive Position Sensor -G676- and Circuit Board 3 -- are integrated in the Sensor Module --. The components can only be replaced as a single Sensor Module -- unit.
Replace the wiring set for the sensor module (-item 39- in OVERVIEW - MECHATRONIC ) when replacing the Sensor Module --.