Oil Pan, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying ATF Fluid Pan Guides & Gasket

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Clean the sealing surfaces.

-- Replace the ATF oil pan bolts and gasket.

-- Insert the guides -arrow- on the new gasket -2- into the ATF fluid pan -1-.

-- Attach the gasket (if equipped) and expanding rivets -3- to the ATF pan.

NOTE:

Clips item -3- are only used for assembly help during production.

-- Clean the magnets -arrows- in the ATF pan.

Fig 2: Locating ATF Fluid Pan Magnets

Courtesy of AUDI OF AMERICA, LLC

-- Make sure the magnets completely contact the depressions in the ATF oil pan.

-- Tighten the ATF oil pan screws, refer to Figure.

Fig 3: ATF Oil Pan Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Fill the ATF after the ATF pan is installed:

Audi A6, A7, refer to OIL PAN, REMOVING AND INSTALLING .