S Tronic Transmission On 6-Cylinder TDI Engine

WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Checking If Alignment Sleeves For Centering Engine/Transmission Are In Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

Item

Bolt

1 ¹⁾

M10x50 ²⁾

2 ¹⁾ , 3 to 6

M12 x 100 ³⁾

30 + 90°

M12 x 125 ³⁾

30 + 90°

M10 x 60 ³⁾

15 + 90°

9, 10

M10 x 95 ³⁾

15 + 90°

Alignment sleeves for centering

¹⁾ Mount the auxiliary adapter
²⁾ Bolt strength rating 10.9. There is no limit to the number of times steel bolts may be used.
³⁾ The bolts may be used two times, refer to S Tronic Transmission On 6-Cylinder TDI Engine .

⁽¹⁾	To prevent damaging the bolts when marking them, do not clamp them in a vise. Insert the bolt using a 14 mm socket with a /₂ drive, which is inserted in to the vise, as shown.

The aluminum bolts -2 through 10- can be used twice. Therefore, the bolts must be marked with two notches "X" made by a chisel after they have be used the first time -arrow-.

Fig 2: Identifying Bolts Marked With An "X" May Not Be Used Again
Courtesy of AUDI OF AMERICA, LLC
Bolts marked with an "X" may not be used again.