Shift Lock Solenoid -N110-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into "P".

-- Remove the front ashtray or storage compartment, refer to FRONT ASHTRAY, REMOVING AND INSTALLING .

-- Loosen the nuts -1, 3, 5 and 6- a few turns but do not remove them completely.

Fig 1: Disconnecting Selector Mechanism Electrical Connectors And Removing Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE:

This lowers the shift mechanism function unit slightly for better accessibility.

Ignore -2 and 4- and -arrow-.

CAUTION:

The shift mechanism can be destroyed by broken clips, tabs or other objects.

Make sure no components or other objects fall into the shift mechanism. The shift mechanism must be replaced if that happens.

-- Open the retaining tabs -2- and -3- in the direction of the -arrow-, slightly raise the front of the sealing cap -A- and hold it in that position.

Fig 2: Identifying Shift Mechanism

Courtesy of AUDI OF AMERICA, LLC

NOTE: This prevents the retaining tabs from engaging again.

-- Open the upper tab -1- in direction of -arrow- above the bracket -B- and remove the cap -A-.

-- Disconnect the connector on the Shift Lock Solenoid -N110-.

Fig 3: Pressing Retaining Hooks Into Shift Mechanism

Courtesy of AUDI OF AMERICA, LLC

-- Push the hook -A- in direction of -arrow- and hold it in this position.

NOTE: Replace the selector mechanism function unit if any of the hooks -A- are broken off.

-- Tilt the Shift Lock Solenoid -N110- in the direction of the -arrow- so that the ball rod -1- comes out of the lever on the selector mechanism.

Fig 4: Identifying Shift Lock Solenoid N110

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Shift Lock Solenoid -N110-.