Selector Mechanism, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the selector mechanism function unit and tighten it from the top.

-- Install selector lever cable, refer to INSTALLING .

-- Adjust the selector lever cable, refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the selector mechanism, refer to GEARSHIFT MECHANISM, CHECKING .

-- Install the driveshaft intermediate bearing, refer to REMOVAL AND INSTALLATION or REMOVAL AND INSTALLATION .

-- Install the front ashtray or storage compartment, refer to FRONT ASHTRAY, REMOVING AND INSTALLING .

-- Install the selector lever handle, refer to INSTALLING .

Perform "Guided Functions" using the Vehicle Diagnostic Tester after removing and installing the selector mechanism function unit, refer to TRANSMISSION GUIDED FUNCTIONS .