Overview - Selector Lever Cable
WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Clip
- For the selector lever cable on the selector mechanism function unit
- O-Ring
- Replacing
- Bolt
- 13 Nm
- For selector lever cable adjustment
- Selector Lever Cable
- Do not bend
- Different versions depending on the vehicle; Use the correct allocation.
- Removing and installing, refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING .
- The selector lever cable must be replaced if the rubber grommet is damaged.
- Lubricate the ball socket lightly with Polycarbamide Grease G 052 142 A2 before installing.
- Make sure the rubber grommet on the transmission side is not twisted when installing.
- Adjusting, refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
- Perform "Guided Functions" using the Vehicle Diagnostic Tester after adjusting the selector lever cable, refer to TRANSMISSION GUIDED FUNCTIONS .
- Selector Lever
- Clip
- Lock nut 13 Nm depending on the version
- For attaching the selector lever cable to the cable bracket
- Cable Mounting Bracket
- Bolt
- 8 Nm
- Bolt
- 8 Nm