Overview - Mechatronic
WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- ATF Drain Plug
- Tightening specification -item 1- OVERVIEW - DRAIN AND CHECK PLUGS => List Item: ATF Drain Plug .
- Seal
- Replacing
- Bolt
- Tightening specification and sequence, refer to MECHATRONIC, REMOVING AND INSTALLING .
- Clip
- For attaching the gasket to the ATF oil pan
- Not required for installation
- Magnet
- Quantity: 2
- insert into the depression in the ATF oil pan
- Make sure the entire surface contacts oil pan
- Bolt
- Tightening specification and sequence, refer to MECHATRONIC, REMOVING AND INSTALLING .
- S Tronic Transmission Mechatronic -J743-
- Refer to MECHATRONIC, REMOVING AND INSTALLING
- After replacing the S Tronic Transmission Mechatronic -J743-, the corresponding "Guided Functions" must be performed with the Vehicle Diagnostic Tester, refer to TRANSMISSION GUIDED FUNCTIONS .
- Disconnecting the S Tronic Transmission Mechatronic - J743- circuit board, refer to MECHATRONIC CIRCUIT BOARD, REMOVING AND INSTALLING .
- Refer to MECHATRONIC, REMOVING AND INSTALLING
- Retaining Plate
- for the ATF oil pipes
- Bolt
- Tightening specification and sequence, refer to MECHATRONIC, REMOVING AND INSTALLING .
- O-Rings
- Are replaced together with the ATF pipe (-item 11-)
- Coat with ATF before installing
- ATF Pipes
- Replacing
- O-Rings
- Are replaced together with the ATF pipe (-item 9-)
- Coat with ATF before installing
- O-Ring
- Replacing
- Coat with ATF before installing
- Bolt
- Tightening specification -item 12-.
- For the Replaceable ATF Filter Housing
- Removing and installing, refer to ATF FILTER HOUSING, REMOVING AND INSTALLING .
- Different versions depending on the date of manufacture, pat attention to the correct allocation.
- ATF Fill and Check Plug
- Tightening specification -item 4- OVERVIEW - DRAIN AND CHECK PLUGS => List Item: ATF Fill and Check Plug .
- Bolt
- Tightening specification and sequence, refer to MECHATRONIC, REMOVING AND INSTALLING .
- Connector Housing
-- Remove the screw -item 17- and turn the connection housing counter-clockwise.
- O-Rings
- Replacing
- Transmission Housing
- Wiring Harness
- Bolt
- Tightening specification and sequence, refer to MECHATRONIC, REMOVING AND INSTALLING .
- ATF Pipes
- ATF Pipes
- Different versions depending on the date of manufacture, one or three pieces
- O-Ring
- Replacing
- O-Rings
- Replacing
- ATF Suction Filter
- Removing and Installing, refer to ATF FILTER, REMOVING AND INSTALLING .
- Seal
- Replacing
- Installing, refer to OIL PAN, REMOVING AND INSTALLING => .
- ATF Pan
- Refer to OIL PAN, REMOVING AND INSTALLING