Oil Pan, Removing And Installing: Installing

Fig 1: Identifying ATF Fluid Pan Guides & Gasket

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Clean the sealing surfaces.

-- Replace the ATF oil pan bolts and gasket.

-- Insert the guides -arrow- on the new gasket -2- into the ATF fluid pan -1-.

-- Attach the gasket and clips -3- to the ATF pan.

-- Clean the magnets -arrows- in the ATF pan.

Fig 2: Locating ATF Fluid Pan Magnets

Courtesy of AUDI OF AMERICA, LLC

-- Make sure the magnets completely contact the depressions in the ATF oil pan.

-- Tighten the ATF pan bolts, refer to OIL PAN, REMOVING AND INSTALLING .

Fig 3: ATF Oil Pan And Bolt Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the right coolant pipe on the transmission, refer to FOR ENGINE(S) CTUA & CGXB - RIGHT COOLANT PIPE ON TRANSMISSION, REMOVING AND INSTALLING , FOR ENGINE(S) CEUC & CRDB - RIGHT COOLANT PIPE ON TRANSMISSION, REMOVING AND INSTALLING or FOR ENGINE(S) CPNB - COOLANT PIPES, REMOVING AND INSTALLING[For engine(s) CPNB] Cooling System .

-- Fill the ATF, refer to ATF Level, Checking .