LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (S TRONIC Transmission - Controls & Housing) >> 34 Controls, Housing >> ATF Circuit >> ATF PIPES, Removing And Installing >> Installing >> Notes

ATF PIPES, Removing And Installing: Installing: Notes

WARNING: This page is about a different car, the 2015 Audi S7, 2014 Audi S7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE: Replace the O-rings.
CAUTION:

Danger of causing damage to the transmission.

  • When disassembling, remove all the plugs, which were taken from the Engine Bung Set VAS 6122, and the ATF pipe/hose line and from the transmission.
  • The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.

-- First insert the ATF pipe/hose lines into the transmission and radiator by hand as far as the stop and then bolt them on.

-- Check and adjust the ATF level after installing the transmission, refer to ATF LEVEL, CHECKING .

scientia non olet · About LEMON Manuals