LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Heating, Ventilation & Air Conditioning (Air Guide, Coolant Circuit, Display&Control Head,Additional Components)) >> 87 Air Conditioning >> Display And Control Head >> Display And Control Head, Removing And Installing >> Rear A/C Display Control Head -E265-, Removing And Installing >> Installing

Rear A/C Display Control Head -E265-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Installation is done is reverse order, observe the following:

-- Note the exact allocation when replacing the Rear A/C Display Control Head -E265-.

Always perform the following work after replacing/installing the Rear A/C Display Control Head -E265-. Use the Vehicle Diagnostic Tester in "Guided Fault Finding" function.

-- Perform and/or check the coding.

-- Perform the basic setting.

-- Read the Diagnostic Trouble Code (DTC) memory (and clear the input for the currently displayed entry).

-- Check the adaptation.

-- If necessary, perform the output diagnostic test.

scientia non olet · About LEMON Manuals