Bracket For The Coolant Recirculation Pump -V50- And Coolant Shut-Off Valve -N82- / Heater Coolant Shut-Off Valve -N279-, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Installation is done is reverse order, observe the following:
-- Tighten the bolts -3- to 8 Nm and the bolts -5- to 1.5 Nm.
-- The mount must be completely pressed into the clip nuts.
-- Install the fresh air intake shroud for vehicles with the Coolant Recirculation Pump V50, refer to FRESH AIR INTAKE, REMOVING AND INSTALLING .