Left/Right Rear Upper Body Vent Temperature Sensor -G635- / -G636-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Vent Temperature Sensors, Connectors And Seal

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center console, refer to CENTER CONSOLE, REMOVING AND INSTALLING .

-- Mark the connectors -1 and 5-.

NOTE:

If the connections -1 and 5- are switched, the respective measured values for the control head will not be recognized and the controls for the A/C system will be faulty. use the Vehicle Diagnostic Tester in "Guided Fault Finding" function.

-- Disconnect the connector -1- and turn the Left Rear Upper Body Vent Temperature Sensor -G635- -2- counterclockwise and remove it from the mount.

-- Disconnect the connector -5- and turn the Right Rear Upper Body Vent Temperature Sensor -G636- -4- counterclockwise and remove it from the mount.