Left/Right Rear Footwell Vent Temperature Sensor -G637- / -G638-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Coupling Station And Cover

Courtesy of AUDI OF AMERICA, LLC

-- Move the respective front seat into the forward most and highest position.

-- Unclip the front cover -1- with the Trim Removal Wedge 3409 and remove the cover in direction of -arrow- from the coupling station -2-.

-- Carefully lift up the carpet on the inside of the coupling station.

-- Turn the vent temperature sensor -1- counterclockwise under the lifted carpet and remove it from the mount.

Fig 2: Vent Temperature Sensor, Connector And Seal

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

NOTE:

If the connectors are preventing access to the vent temperature sensor, disconnect the connectors from the front seat while observing the safety precautions, refer to SAFETY PRECAUTIONS .