Air Ionization System Control Module -J897-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Air Ionization System Control Module Component Location Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Market-specific only in the "Comfort" version.

-- Place the right front seat as far forward as possible.

-- Remove the right B-pillar air duct, refer to B-PILLAR AIR GUIDE, REMOVING AND INSTALLING .

-- Turn the ionizer -3- counterclockwise -arrow A- and remove it from the mount.

-- Free up the wiring harness -2-.

-- Remove the adhesive strips, if equipped.

-- Open the tabs -1- -arrow B- and remove the air ionization system control module -4- downward from the mount -arrow C-.