Condenser, Removing And Installing: Removing
-- Discharge the refrigerant circuit, refer to REFRIGERANT CIRCUIT, DISCHARGING WITH SERVICE STATION or REFRIGERANT CIRCUIT, DISCHARGING WITH SERVICE STATION .
Audi RS6/RS7
-- Remove the impact member, refer to IMPACT MEMBER, REMOVING AND INSTALLING .
-- Remove the A/C Pressure/Temperature Sensor -G395-, refer to A/C Pressure/Temperature Sensor -G395-, REMOVING AND INSTALLING .
Audi A6/A7
-- Remove the lock carrier cover, refer to LOCK CARRIER .
-- Remove the bolts -arrows-, if applicable.
-- Remove the air guide -1-.
-- Remove the bolts -arrows-.
-- Remove the air guide -1- on the intermediate flange -2- for the air filter housing.
Continuation for All
-- Remove the refrigerant lines from the condenser, refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .
-- Release the tabs -A arrows- and remove the left and right air guide -1- -arrow B-.
High Voltage System Vehicles
-- Remove the bolts -arrows-.
-- Disengage the front radiator -1- upward and pivot to the side with the air guide -2- and move it to the side with the coolant hoses still attached.
For All Vehicles
-- Disconnect the connector from the A/C Pressure/Temperature Sensor -G395-.
-- Have a second technician open the tabs -1- in direction of -arrow A- and pull the condenser -2- upward out of the mounts on the radiator -arrows B-.