Overview - Impact Member, Audi A7/S7
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 3.5 Nm
- Quantity: 3
- Grommet
- For the cable
- LED Indicator Lamp
- Make sure the trailer hitch is locked correctly
- Mount
- For the cable
- Removing and installing. Refer to CABLE MOUNT, REMOVING AND INSTALLING .
- Bolt
- 2 Nm
- Quantity: 3
- Bolt
- Quantity: 3
- Tightening sequence. Refer to Fig 2
- Foam Seal
- Replace if damaged
- Nut
- 23 Nm + 90°
- Replace after removing
- Impact Member
- For vehicles without a trailer hitch
- Removing and installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES WITHOUT TRAILER HITCH, AUDI A7/S7 .
- Pull Knob
- For unlocking the trailer hitch
- Removing and installing. Refer to CABLE MOUNT, REMOVING AND INSTALLING .
- Lock Clamp
- For the pull knob
- Spring Nut
- Quantity: 3
- Bolt
- Replace after removing
- Quantity: 2
- Tightening sequence. Refer to Fig 3
- Impact Member
- For vehicles with a trailer hitch
- Removing and installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES WITH TRAILER HITCH .
- Socket
- Removing and installing. Refer to TRAILER HITCH .
- Connector assignment. Refer to TRAILER HITCH .
-- Tighten the bolts in a -1 to 6- sequence to 30 Nm.
-- Tighten the bolts to 50 Nm +90° in the following sequence: -1 through 4-.