Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Engage the accelerator pedal module -4- on the bottom of the pedal bracket -1-, insert the centering pin -2- and tighten the bolt -3-.
-- Install the driver side lower instrument panel cover, refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .
-- Depending on the engine/transmission version, adaptation in the "Guided Functions" operating mode is necessary after replacing it. Perform the adaptation, if a menu item is available in the "Guided Function", refer to Vehicle Diagnostic Tester.