Fuel Pump Control Module -J538-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuel Tank Bolts

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Tighten the bolts -1 through 6- on the mounting strap and the support plate.

-- Tighten the fuel filler tube bolts -1- and -2-.

Fig 2: Locating Fuel Filler Tube Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Install the right locking flange cover, refer to Figure.

-- Install the rear bench seat, refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .

-- Connect the battery. While doing so, follow all steps after connecting the battery, refer to BATTERY, DISCONNECTING AND CONNECTING .