LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (3.0L & 4.0L - Fuel Supply - Engine Code(S): CEUC, CGXB, CRDB & CTUA) >> 20 Fuel Supply >> Accelerator Pedal Mechanism >> Accelerator Pedal Position Sensors -G79 - / - G185 -, Removing And Installing >> Installing

Accelerator Pedal Position Sensors -G79 - / - G185 -, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Accelerator Pedal Module With Accelerator Pedal Position Sensor
GWWA20-10432Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Engage the accelerator pedal module -4- on the bottom of the pedal bracket -1-, insert the centering pin -2- and tighten the bolt -3-.

-- Install the driver side lower instrument panel cover, refer to INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

NOTE:

An adaptation may need to be performed after replacing, depending on the engine/transmission combination.

If there is a menu option in "Guided Functions", perform an adaptation see Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals