LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Instruments) >> 90 Instruments >> Removal And Installation >> Cigarette Lighters And 12 Volt Outlets >> Cigarette Lighter -U1-

Cigarette Lighter -U1-

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required 

Removal 

Fig 1: Cigarette Lighter Illumination
GWWA90-10077Courtesy of AUDI OF AMERICA, LLC

-- Remove the front ashtray. Refer to FRONT ASHTRAY, REMOVING AND INSTALLING .

-- Pry off the cover -1- over the Cigarette lighter illumination bulb -L28- -arrows-.

-- The release tabs -2- on the release tool T40148 must engage in the openings in the cigarette light -3- -arrow- and the threaded pin -1- must slide down as far as the stop.

Fig 2: 12 V Socket 5 -U26- -Item 3
GWWA90-10090Courtesy of AUDI OF AMERICA, LLC

-- Slide the T40148 into the cigarette lighter -1- as far as the stop.

Fig 3: Identifying T40148
GWWA90-10043Courtesy of AUDI OF AMERICA, LLC

-- Rotate the thumb-wheel -2- on the T40148 clockwise as far as the stop.

-- Remove the cigarette lighter using the T40148 from the Cigarette lighter illumination -L28-.

-- Open the clips -arrows-.

Fig 5: Identifying Socket Illumination Bulb
GWWA90-10140Courtesy of AUDI OF AMERICA, LLC

-- Remove the cigarette lighter and illumination ring -1- from the front ashtray -2-.

-- Guide the wire through the mount.

Installation 

Fig 6: Identifying Support, Thumbwheel, Release Tabs, Release Tool T40148 & Cigarette Lighter
GWWA90-10091Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal, observing the following:

CAUTION:

Risk of injury.

  • After removing the T40148, check to see if the lighter retaining tabs are bent.
  • If the retaining tabs are bent, bend them back so the lighter does not slide out.

-- Remove the support -1- on the T40148.

-- Slide the piston down and hold it in place.

-- Rotate the thumb-wheel -4- on the T40148 counterclockwise -arrow-. This loosens the release tabs -2- on the cigarette lighter -item 3- so the T40148 can be removed.

-- Install the front ashtray. Refer to FRONT ASHTRAY, REMOVING AND INSTALLING .