Steering Wheel, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Applies to vehicles equipped with dynamic steering:

Before the steering wheel can be removed from the steering column, the steering wheel must be in the exact horizontal using the Steering Wheel Scales VAS 6458. Mount the new steering wheel so that it is horizontal using the Steering Wheel Level VAS 6458.

After doing this step, the Steering Angle Sensor -G85- for setting the steering wheel position must be checked. While doing this, select the appropriate measured values block in the Steering Column Electronics Control Module -J527- in on board diagnostics. If the displayed value is > 0.5°, then the Steering Angle Sensor -G85- must be calibrated again and the dynamic steering must be adapted, by starting the correct program using the Vehicle Diagnostic Tester in Guided Functions .

-- Straighten the wheels.

-- Position steering wheel as far back as possible. Use entire steering column adjustment range to do this.

-- Remove the driver side airbag, refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .

NOTE:

Removal and installation of steering wheel must take place in center position (wheels in straight-ahead position).

-- Remove the bolt -1-.

Fig 1: Removing Steering Wheel

Courtesy of AUDI OF AMERICA, LLC

-- Mark position of steering wheel/column with a felt-tip pen.

-- Remove steering wheel -2- from steering column.