Tie Rod, Removing And Installing: Installing: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
Replace the boot each time it is removed.
Coat the inside of slits in the boot all the way around and evenly with power steering gear grease before installing.
Check the seat for the boot on the steering gear for damage before installing. If the steering gear housing is damaged, replace the steering gear.
-- Attach the tie rod using the Torque Wrench Insert - Open Jaw VAG 1923 -2-. Counter hold at the power steering gear coupling rod with an open end wrench -1-.
-- Replace the spring clamp -3- and the clamp -1-.