Clamping Sleeves, Installing:
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
-- Install a new clamp -1- and tension it, refer to Tensioning the Inner Clamp .
Boot Assembly
- Dimension -a- 2 mm.
-- Align tie rod so that tie rod ball joint pints are in installation location.
-- Insert the tie rod into the wheel bearing housing as far as the stop.
-- Install the front wheel, refer to WHEELS AND TIRES .
-- Axle alignment, refer to the table in EVALUATING NEED FOR AXLE ALIGNMENT .
The axle alignment must be performed on a VW/Audi approved alignment stand.