Overview - Electro-Mechanical Steering Gear With Tie Rods
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Electro-Mechanical Steering Gear with Tie Rods
- With Power Steering Control Module -J500-
- Removing and installing, refer to STEERING GEAR, REMOVING AND INSTALLING .
- Servicing, refer to OVERVIEW - STEERING GEAR .
- There are different versions.
A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.
A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and installing on a new steering gear.
A replacement steering gear comes with the bonded heat shield mat.
- Bolt
- 80 Nm +180° turn
- Always replace if removed
- Subframe
- Nut
- Pushed into the subframe
- Always replace if removed
- Steering Intermediate Shaft
- Bolt
- Tightening specification -item 1- in Figure.
- Wheel Bearing Housing
- Nut
- 100 Nm
- Always replace if removed