Electronic Steering Column Lock Control Module -J764-, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Note the following before removing the steering column:
Create a sketch showing the:
- Routing of the electrical wiring harnesses,
- Securing the electrical wiring harnesses,
- Cable tie locations.
This especially applies to the wiring harness to the Electronic Steering Column Lock Control Module -J764-.
Note the following before installing the steering column:
- Route the electrical wiring harnesses exactly the way they were before removal.
- Secure the electrical wiring harnesses exactly the way they were before removal.
- Install all the cable ties that were loosened or cut in the same locations when installing the steering column.
- Make sure the wiring harness to the Electronic Steering Column Lock Control Module -J764- is not pinched and does not come into contact with sharp edges when adjusting the steering column.
-- If the control module is being replaced, then select "replace" control module on the Vehicle Diagnostic Tester in Guided Functions .
-- Remove the steering column, refer to STEERING COLUMN, REMOVING AND INSTALLING .
-- Remove the bolt -1- and the Electronic Steering Column Lock Control Module -J764- -2-.
WARNING:
- After removing the control module, make sure no dirt or foreign objects enter the steering column.