Active Steering Safety Lock (Locking Magnet), Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- After replacing the Active Steering Safety Lock Actuator -F437- (dynamic steering), update the software for the Active Steering Control Module -J792- by starting the corresponding program on the Vehicle Diagnostic Tester in Guided Functions .
- If a new Active Steering Safety Lock Actuator -F437- (dynamic steering) is installed, transfer the marking from the old one to the new one.
-- Install the new actuator as shown in the following table and secure it with both new bolts -1 and 2- (use the supplied tool).