Wheel Bearing Unit, Servicing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Shop Press VAG 1290A
Press Plate VW 401
Press Plate VW 402
Press Piece - Multiple Use VW 412
Hydraulic Press - Bushing Assembly Tool Kit T10230
-3- Puller - Kukko Separating Tool - Diameter 25-155 mm with Puller - Kukko Quick Action Separating Tool - 25-155 mm 15/3 with 17/3

Procedure

Wheel bearing housing is removed, refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .

Wheel Hub, Removing from Wheel Bearing

Fig 1: Identifying Tool Set Up/Assembly

Courtesy of AUDI OF AMERICA, LLC

-- Install special tools as shown in illustration.

Press Piece - Multiple Use VW 412
Sleeve T10230/3 from the Hydraulic Press - Bushing Assembly Tool Kit T10230
Thrust Piece T10230/8 from the Hydraulic Press - Bushing Assembly Tool Kit T10230
Wheel bearing unit
Press Plate VW 402
Press Plate VW 401

-- Press the wheel hub out of the wheel bearing.

Fig 2: Inserting Separating Tool Between Bearing Inner Race And Wheel Hub

Courtesy of AUDI OF AMERICA, LLC

-- Insert the separating tool between the bearing inner race -1- and the wheel hub -2- and pretension with the spindle.

NOTE:

Use a commercially available separating tool such as the Puller - Kukko Separating Tool - Diameter 25-155 mm with Puller - Kukko Quick Action Separating Tool - 25-155 mm 15/3 with 17/3.

-- Install special tools as shown in illustration.

Fig 3: Identifying Tool Set Up/Assembly

Courtesy of AUDI OF AMERICA, LLC

Press Piece - Multiple Use VW 412
Sleeve T10230/3 from the Hydraulic Press - Bushing Assembly Tool Kit T10230
Thrust Piece T10230/8 from the Hydraulic Press - Bushing Assembly Tool Kit T10230
Puller - Kukko Separating Tool - Diameter 25-155 mm with Puller - Kukko Quick Action Separating Tool - 25-155 mm 15/3 with 17/3

-- Press the bearing inner race from the hub.

Pressing Wheel Hub Into Wheel Bearing

Fig 4: Identifying Tool Set Up/Assembly

Courtesy of AUDI OF AMERICA, LLC

-- Install special tools as shown in illustration.

Press Piece - Multiple Use VW 412
Press Plate VW 402
Wheel hub
Ball Bearing
Press Plate VW 401

NOTE:

The reworked surface on the wheel bearing outer race faces down.

CAUTION:

When setting down or pressing in, make sure there is no dirt or contaminants between the Press Plate VW 401 -5- and the ball bearing -4-.

-- Press the wheel hub into the wheel bearing.

-- Install the wheel bearing unit, refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .