Wheel Bearing Unit, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Install the drive axle, refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Install the wheel, refer to WHEELS AND TIRES .
-- On vehicles with automatic head lamp range control, perform headlamp basic setting, refer to DIAGNOSIS AND TESTING .
-- If the Level Control Sensor -- was removed and installed or if the linkage was loosened, the control position must be programmed again by starting the correct program on the Vehicle Diagnostic Tester in Guided Functions .
-- If the control position was reprogrammed on vehicles with lane assist, the Camera Control Module -J852- must be calibrated again, refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .