LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Front Suspension) >> 40 Front Suspension >> Subframe >> Stabilizer Bar, Removing And Installing >> Removing

Stabilizer Bar, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Noise Insulations
GWWA10-11234Courtesy of AUDI OF AMERICA, LLC

-- Place the vehicle on a hoist, refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .

-- Remove the noise insulation -1-, refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Disconnect left and right connectors -2-.

Fig 2: Identifying Stabilizer Bar Fasteners
GWWA40-10325Courtesy of AUDI OF AMERICA, LLC

-- Remove the left and right threaded connector -1- and remove the clamps -3-.

-- Remove the stabilizer bar.