Fastener Tightening Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
| Component | Fastener Size | Nm |
|---|---|---|
| Air Line Connecting Piece | - | 3 |
| Air Spring Boot Clamp | - | 8 |
| Air Spring Shock Absorber to Shock Absorber Fork Bolt 1 | - | 40 + 180° |
| Air Spring Shock Absorber to Suspension Strut Dome Nut 1, 5 | - | 30 |
| Ball Joint to Wheel Bearing Housing Bolt 1 | - | 40 |
| Coil Spring Shock Absorber to Shock Absorber Mounting Nut 1 | - | 50 |
| Coupling Rod to Shock Absorber Fork Bolt 1, 3 | - | 40 + 90° |
| Coupling Rod to Stabilizer Bar Bolt1, 3 | - | 40 + 90° |
| CV Joint Boot Clamp | - | 20 |
| Drive Axle to Transmission Bolt | M10 | 70 |
| Drive Axle to Wheel Hub Bolt 1 | - | 200 + 180° turn |
| Front Lower Longitudinal Member to Subframe Bolt | - | 20 |
| Guide Link to Subframe Bolt 1, 3 | - | 70 + 180° |
| Guide Link to Wheel Bearing Housing Nut 1 | - | 140 |
| Level Control System Sensor Bolt/Nut | - | 9 |
| Shock Absorber Fork to Track Control Arm Nut 1, 3 | - | 90 + 90° |
| Stabilizer Bar to Subframe Nut 1, 4 | - | 25 |
| Subframe to Body Bolt 1, 2 | - | 115 + 90° |
| Subframe Crossbrace to Subframe Bolt 1 | - | 90 +180° |
| Subframe Heat Shield to Subframe Bolt/Nut | - | 9 |
| Tower Brace to Body Bolt | - | 20 |
| Track Control Arm to Ball Joint Nut 1 | M12 | 120 |
| M14 | 140 | |
| Track Control Arm to Subframe Nut 1, 3 | - | 70 + 180° |
| Upper Control Arm to Subframe Bolt 1, 3 | - | 50 + 90° |
| Upper Control Arm to Wheel Bearing Housing Nut 1 | - | 40 |
| Wheel Hub to Wheel Bearing Housing Bolt 1 | - | 80 + 90° |
|
||