Ball Joint, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi A7 Quattro, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Install the ball joint -1- into the wheel bearing housing -2- as far as the contact surface -arrows-.
NOTE:
If the ball joint -1- is not inserted up to the contact surface -arrows- then the threaded connection on the wheel bearing housing -2- could get damaged.
-- Install the control arm, refer to CONTROL ARM, REMOVING AND INSTALLING .
-- Install the wheel, refer to WHEELS AND TIRES .
-- Axle alignment, refer to the table in EVALUATING NEED FOR AXLE ALIGNMENT .