Engine Coolant Temperature Sensor -G62-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Coolant Reservoir Cap

Courtesy of AUDI OF AMERICA, LLC

The engine is cold.

-- Briefly open the coolant reservoir cap -arrow- to reduce the residual pressure in the coolant system.

-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

Fig 2: Connector & Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1-, and remove the Engine Coolant Temperature Sensor -G62-.