Check Valve, Removing And Installing, Cylinder Bank 1 (Right): Removing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the coolant, refer to Draining .

-- Remove the right engine mount, refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- When installed: remove the nut -1-, free up the Ground (GND) wire at the right engine support

Fig 1: Removing Nut And Freeing up Ground Wire

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the right engine support.

NOTE:

Illustrated is the engine support without the heat shield.

-- Remove the bolt -arrow-.

Fig 2: Remove Bolt & Check Valve

Courtesy of AUDI OF AMERICA, LLC

-- Remove the check valve -1-.