Left Coolant Pipes, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-ring.

Replace any bolts that were tightened with an additional turn.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Clean and smooth the O-ring sealing surface.

-- Coat the O-ring with coolant and slide it onto the coolant pipe.

-- Install the engine support with the A/C compressor bracket and the left engine mount, refer to OVERVIEW - SUBFRAME MOUNT .

-- Install the ribbed belt, refer to RIBBED BELT, REMOVING AND INSTALLING, ACCESSORY RIBBED BELT .

NOTE: Do not reuse used coolant.

-- Fill the coolant, refer to FILLING .