LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Wheels & Tire - General Information) >> 44 Wheels, Tires, Wheel Alignment >> Wheels/Tires/Tire Pressure Monitoring Assembly >> Wheel Electronics, TPMS, Beru System

Wheel Electronics, TPMS, Beru System

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required 

Siemens wheel electronics system, refer to WHEEL ELECTRONICS, TPMS, SIEMENS SYSTEM .

Fig 1: Identifying Tire Pressure Monitor
GWWA44-10029Courtesy of AUDI OF AMERICA, LLC
WARNING:

If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.

WARNING:

Damaged wheel electronics must be replaced.

-- Push the wheel electronics -1- into the bed.

Fig 2: Pressing Wheel Electronics Into Bed
GWWA44-0086Courtesy of AUDI OF AMERICA, LLC

-- Install on the valve from the back with a microencapsulated screw  Microencapsulated Screw -6-.

NOTE:

Replace the microencapsulated screw.

Tighten the microencapsulated screw to 4 Nm on all models.

Tightening specification for all models: 4 Nm