Rear Axle Toe, Adjusting

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Track Rod Tool Insert T40183

-- Remove the nut -A- of threaded connection tie rod/subframe, and screw on new nut until stop.

Fig 1: Identifying Bolt & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Adjust toe by turning eccentric bolt -B-.

Axle alignment specified values, refer to AXLE ALIGNMENT SPECIFIED VALUES .

-- Tighten the nut -A- using the Track Rod Tool Insert T40183 -item 4- in OVERVIEW - TRANSVERSE LINK .

-- After tightening nut -A-, check toe value once more, refer to AXLE ALIGNMENT SPECIFIED VALUES .

NOTE:

The maximum adjustment range is 90° to left or right of center position.

The geometric drive axle is automatically changed when individual toe settings are changed.