Rear Axle Camber, Adjusting

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the nut -A- of threaded connection of wheel bearing housing/control arm, and screw on new nut until stop.

Fig 1: Identifying Camber Adjusting Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the camber by rotating the adjusting bolt -B-. To turn the adjusting screw -B-, turn the hex head at the >>top of the screw<<.

Axle alignment specified values, refer to AXLE ALIGNMENT SPECIFIED VALUES .

NOTE:

The maximum adjustment range is 135° to left or right of center position.

Do not rotate the adjusting bolt -B- further once the end position has been reached or the components will be damaged.

For a better illustration, camber adjustment is shown with wheel removed.

-- Tighten nut -A- -item 13- in OVERVIEW - TRANSVERSE LINK .

-- After tightening nut -A-, check camber value once more, refer to AXLE ALIGNMENT SPECIFIED VALUES .