Sportback Front Axle With RHD And Standard Suspension, Determining The Camber Value 1BA
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
For the Audi Sportback with RHD and standard suspension 1BA the camber value on the front axle is determined according to the vehicle height.
-- Measure the vehicle height -a- at the right and left front wheels between the center of the wheel and the lower edge of the fender.
- The maximum permissible height difference between right and left ≤ 10 mm.
Camber Value Determination Example:
Camber value = -53' + [(vehicle height left + vehicle height right) : 2] - 396
NOTE:
1' camber = 1 mm vehicle height
The Camber Values Are Defined in the Following Table Based on the Vehicle Heights at the Front Axle.
| Sportback Front Axle with RHD and Standard Suspension Camber Value 1BA | ||||||
|---|---|---|---|---|---|---|
| Vehicle Height | Camber | Maximum permissible difference in height between the right and left | ||||
| Drift | Left and right average absolute value Wheel | Average Delta or specified vehicle height in mm | Camber value (test value / adjustment value) | Drift | Maximum permissible difference between both sides | |
| Too high | 406 | 10 | -43' | ± 23' | 30' | ≤ 10 mm |
| 405 | 9 | -44' | ||||
| 404 | 8 | -45' | ||||
| 403 | 7 | -46' | ||||
| 402 | 6 | -47' | ||||
| 401 | 5 | -48' | ||||
| 400 | 4 | -49' | ||||
| 399 | 3 | -50' | ||||
| 398 | 2 | -51' | ||||
| 397 | 1 | -52' | ||||
| Specified | 396 | 0 | -53' | |||
| To low | 395 | -1 | -54' | |||
| 394 | -2 | -55' | ||||
| 393 | -3 | -56' | ||||
| 392 | -4 | -57' | ||||
| 391 | -5 | -58' | ||||
| 390 | -6 | -59' | ||||
| 389 | -7 | -60' | ||||
| 388 | -8 | -61' | ||||
| 387 | -9 | -62' | ||||
| 386 | -10 | -63' | ||||