Sedan/Avant Front Axle With RHD And Standard Suspension, Determining The Camber Value 1BA

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

For the Audi sedan/Avant with RHD and standard suspension 1BA the camber value on the front axle is determined according to the vehicle height.

Fig 1: Measuring Vehicle Height -a-

Courtesy of AUDI OF AMERICA, LLC

-- Measure the vehicle height -a- at the right and left front wheels between the center of the wheel and the lower edge of the fender.

The maximum permissible height difference between right and left ≤ 10 mm.

Camber Value Determination Example:

Camber value = -43' + [(vehicle height left + vehicle height right) : 2] - 404

NOTE:

1' camber = 1 mm vehicle height

The Camber Values Are Defined in the following Table Based on the Vehicle Heights at the Front Axle.

Sedan/Avant Front Axle with RHD and Standard Suspension Camber Value 1BA
Vehicle height			Camber			Maximum permissible difference in height between the right and left
Drift	Left and right average absolute value Wheel	Average Delta or specified vehicle height in mm	Camber value (test value / adjustment value)	Drift	Maximum permissible difference between both sides
Too high	414	10	-33'	± 23'	30'	≤ 10 mm
	413	9	-34'
	412	8	-35'
	411	7	-36'
	410	6	-37'
	409	5	-38'
	408	4	-39'
	407	3	-40'
	406	2	-41'
	405	1	-42'
Specified	404	0	-43'
To low	403	-1	-44'
	402	-2	-45'
	401	-3	-46'
	400	-4	-47'
	399	-5	-48'
	398	-6	-49'
	397	-7	-50'
	396	-8	-51'
	395	-9	-52'
	394	-10	-53'