Overview - Active Steering Control Module -J792-: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Follow the sequence when installing the control module:

-- Attach the bracket -4- to the control module -7- with the bolts -5-.

Fig 1: Identifying Night Vision System Control Module & Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Connect the wiring harness connectors -3- to the control module -7-.

-- Carefully slide the wiring harness clip connection -3- into the bracket -4-.

-- Insert the control module with the bracket.

-- Connect the GND wire -2- to the threaded pin and tighten the nuts -1-.

-- Tighten the nuts -6-.

-- If equipped, place the Night Vision System Control Module -J853- E-box with the 2 pins into the seat crossmember and place the front retainer over the stud bolt.

-- The basic setting must be performed on the system if the Active Steering Control Module -J792- was replaced, refer to DYNAMIC STEERING BASIC SETTING .