LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (3.0L - Engine Assembly - Engine Code: CPNB) >> 10 Engine Assembly >> Subframe Mount >> Transmission Mount, Removing And Installing >> Transmission Mount, Removing And Installing, Vehicles With DSG Transmission 0B5 >> Installing

Transmission Mount, Removing And Installing, Vehicles With DSG Transmission 0B5: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Place the transmission support -4- on the transmission mount -3-.

-- Tighten the nut -5- and bolt -6- hand-tight.

-- Tighten the bolt -1- for the stop -2-.

-- Tighten the nut -5- and bolt -6-.

-- Install the transmission support with the transmission mount, refer to TRANSMISSION SUPPORT WITH TRANSMISSION MOUNT, REMOVING AND INSTALLING, VEHICLES WITH DSG TRANSMISSION .

scientia non olet · About LEMON Manuals